|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good quality instructions manual. Very useful to me. Quick and excellent service from Owner-Manuals... Thanks !!!
;
Sono molto soddisfatto e, quando mi necessiterà, mi avvarrò nuovamente di questo servizio!
;
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
;
SCANNING OF HIGH QUALITY
VERY, VERY HIGH VELOCITY DOWNLOAD
VERY GOOD PRICE,
TRUE SATISFIED, THANKS
;
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
Apply covers (C-D) on joint cover lugs and into hinge holes. Snap vent grille (B) and hinge cover (E) into position.
Should the lining up of the furniture door be necessary, use the clearance of slots.
D C
At the end of operations, it is necessary to check if the door of the furniture closes properly.
E
B
PR168
Hb
Separate parts Ha, Hb, Hc, Hd as shown in the figure.
Fix cover (Hd) on guide (Hb) until it clips into place.
Ha Hb
Hb
Hc Hd
Hd
PR266
PR167/1
Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes.After having drilled holes, fix the guide with the screws supplied.
ca. 50 mm
90°
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient
21 mm
temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
ca. 50 mm
21 mm
Fix cover (Hc) on guide (Ha) until it clips into place
Ha
Hc
PR33
Open the appliance door and the furniture door at 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied.
10
PR167
8mm
Ha Hb
11
|
|
|
> |
|
